A Few Words About Guitar Setups……
When is it necessary to “set up” for perfect guitar tuning?
Guitar tuning and setups especially relevant to good music. Since we set up guitar properly, as a result you’ll notice: The guitar feels and sounds its best. All the strings sound with exactly the notes they are supposed to. All notes sound correct when played at each fret up and down the neck. First of all the guitar tuning will proper and guitar be easy to play. Secondly, strings will break less frequently. In addition if a guitar plays easily and sounds its best then it’s easy for the player to feel the music and play well.
What difference does a guitar set up make?
A guitar not set up properly you’ll notice: While yet, the guitar may not feel or sound quite right. Some notes may sound correct while some others may sound sharp or flat. The guitar may be difficult to play. Because strings will break more often then action is too high we lower it.
How is a set up accomplished?
Adjusting action at the bridge for better guitar tuning:
Since adjusting the action at the bridge is done. As a result easier play makes a difference. The bridge saddles should be lowered if the string action is too high, that is, the strings are too far up off the fret board. In some cases it is desirable to raise the saddles for a higher string action.
Lower Saddles For Closer Action
Lower the saddles too much and the strings might rattle against certain frets (this this does not always translate through an amplifier). In more extreme cases, pressing a string against one fret might actually fret the string against a different fret. usually the one under the original one. As a result, filing or leveling the frets will fix the problem. Consequently the saddle should be a comfortable height. Raising the saddle on the other hand a small amount, and the problem should be fine.
Filing frets should only be done by a qualified repair person. Do this only to correct problems with very high frets. Then consequently buzzing or strings will stop. Much as we’d like to think, it doesn’t always solve the problem of accurate guitar tuning.
Filing the nut
We file the nut. This should only be done by a qualified repair person and will reduce pressure at the nut to allow a heavier gauge of strings to be used and better guitar tuning.
Neck/truss rod adjustment
The particular adjustment will ruin guitars when performed incorrectly, so here referral to a professional repair person is highly recommended. We give the guitar a truss rod adjustment if the neck is not straight. One way to check the straightness of the neck is to Site down the side of the neck and check if there is a dip. Sound the open note and the fretted 12th fret note. It should be exactly the same pitch. If it is not, the neck will need adjustment. However, this may be indicative of an intonation problem as well, give the guitar to a repair person.
We check each string on the bridge sits in a “saddle”. Depending on your setup, you can tell the saddles may be in different positions: some will be pushed forward and others might be pushed back, sometimes slightly. The positioning of the saddle effectively changes the length of the vibrating string. Tune the guitar to concert pitch with an electronic tuner, making sure the open strings are perfectly in tune. Play the open string and 12th fret harmonics, then play the fretted notes. If the fretted notes are sharp, the string is too short and the saddle needs to be pushed back toward the base of the bridge. If the note is flat, the string is too long and the saddle needs to be pushed up toward the nut. Repeat this procedure for each string. Adjusting the intonation should be done every few months or at least twice a year.
Leave A Comment
You must be logged in to post a comment.