guitar rewiring guitar pickups http://haywirecustomguitars.com/contactus.html

Installing a bolt-on guitar neck involves carefully attaching and aligning the neck to the guitar body using screws, ensuring proper alignment and a secure fit. This process requires precision to avoid damaging the guitar and to achieve optimal playability. Here's a step-by-step guide: 1. Preparation: Test Fit: Before any drilling, ensure the neck fits into the neck pocket. Alignment: Use the two E strings as guides to align the neck perfectly with the body. Marking: Mark the screw hole locations on the neck using a pencil. Depth Gauge: Use tape on the drill bit as a depth gauge to prevent drilling too deep. 2. Drilling: Pilot Holes: Drill pilot holes in the neck pocket, slightly smaller than the screw diameter. Clearance Holes: Drill clearance holes through the neck, ensuring they are large enough for the screws to pass through without binding. 3. Installation: Clamp: Use a clamp to hold the neck in place while you install the screws. Screws: Apply a lubricant (like dish soap) to the screw threads to help them turn smoothly. Secure: Tighten the screws on the bottom first then the two top screws. 4. Setup: Check Alignment: After installing the neck, double-check the alignment and adjust if necessary. String Action: Adjust the string height (action) to your preference. Intonation: Set the guitar's intonation to ensure proper tuning across the fretboard. Additional Tips: Neck Angle: Aim for a neck angle of 0-5 degrees relative to the body. Shims: If necessary, use shims to adjust the neck angle. Finish: Be careful not to damage the guitar's finish during the process. Professional Help: If you're not comfortable with this process, seek help from a professional guitar technician at Haywire Custom Guitars Inc. USA.